Logo

P03CA BMW Fault Code

Check P03CA OBD Fault Code Reason
Description:

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

P03CA Code Symptoms :

See P03CA in engine

If your vehicle failed a P03CA test and the P03CA Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses P03CA a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look : Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.

Diagnosis And Repairing P03CA

P03CA OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix P03CA code ?

  • Engine Control Module (ECM)
  • Faulty Fuel injector
  • Faulty Air Flow Meter
  • Faulty Camshaft Position Sensor

As the engine heats up and combustion becomes easier and more complete, the PCM will command the idling control valve to increase the amount of air entering the engine to suit the changing conditions.

However, when the load on the engine changes, say, when some electrical consumers or other systems are either turned on or off, the PCM adapts the signal voltage to the idle control valve to ensure that the idling speed remains stable, and at the RPM specified by the manufacturer.

BMW Cars that meet P03CA error